We offer reliable & cost-effective spare parts for the Philips Achieva 1.5T MRI system helping you minimize downtime & keep operations smooth. Wide inventory available. Quick turnaround time. Expert support. Worldwide delivery. Contact Limor@elsmed.com
ADEMETAN OLUWASEGUN
x axis controller loop error
November 09, 2012 10:08
hello colleagues, can anyone help out? my siemens magnetom c MRI during a scanning procedure of the neck suddenly developed some technical problems.The error message displayed was GRADIENT POWER AMPLIFIER ERROR. X-AXIS CONTROLLER LOOP ERROR OR CONTROLLER ERROR SIGNAL TOO HIGH.POWER STAGE'S TEMPERATURE TOO HIGH ( HEAT SINK OR AIR )
segun_ademetan@yahoo.co.uk
thanks
to rate and post a comment
Lenny Place
re: x axis controller loop error
November 09, 2012 05:33
Check your secondary chiller and connectors to the gradient check your chiller flow to the gradient.
to rate and post a comment
Marshall Shannon
re: x axis controller loop error
November 10, 2012 12:13
Change your x gradient
to rate and post a comment
ADEMETAN OLUWASEGUN
re: re: x axis controller loop error
November 10, 2012 07:30
thanks !! what are the steps in doing that
to rate and post a comment