I have a problem with a BV 25 which takes very high KV in auto mode after tracing out I found that the board WN 11 which is the camera control board is supposed to give an output of 1.5 volts between MP2 and 0 and you have to adjust the trimpot TAVORG to get 1.5 volts, however I found that it was giving only 0.3 volts and after adjusting TAVORG it was giving a max of 1.2volts after which it started behaving properly, however it is not getting adjusted to 1.5volts as required any reason as to why ? Thanks
From preventive maintenance through comprehensive cryogen services, BMI-PMI is your trusted partner for new/reconditioned sales, installation, and service of both facility-based and mobile MRI solutions. www.brownsmedicalimaging.com / 800-701-9729
Felix Donoghue
Philips BV 25
July 16, 2004 12:28
I have a problem with a BV 25 which takes very high KV in auto mode after tracing out I found that the board WN 11 which is the camera control board is supposed to give an output of 1.5 volts between MP2 and 0 and you have to adjust the trimpot TAVORG to get 1.5 volts, however I found that it was giving only 0.3 volts and after adjusting TAVORG it was giving a max of 1.2volts after which it started behaving properly, however it is not getting adjusted to 1.5volts as required any reason as to why ? Thanks
to rate and post a comment
Krikor Najarian
Re: Philips BV 25
July 17, 2004 02:18
Felix
I have a BV25 which is not working. I do not have a service manual to repair. (far worse then your problem :)). Can I have/buy a copy of your manual?
Regards
Krikor Najarian
krinaj@yahoo.com
to rate and post a comment
Abdul Hamid Chaudhry
Re: Philips BV 25
July 27, 2004 09:49
Dear Friend,
Have you Fix the Problem of your BV-25?.
Kindly Inform ASA possible.
Best Regards to all of you
medkt@lhr.paknet.com.pk
to rate and post a comment
Felix Donoghue
Re: Philips BV 25
July 28, 2004 07:49
yes problem is still unsolved.
to rate and post a comment