Over 900 Cleansweep Auctions End Today - Bid Now Over 550 Total Lots Up For Auction at Four Locations - Over 10 California Auctions End Tomorrow 07/17 - Bid Now, VA 07/21, CA 07/22, KS 07/24
Hey there friends, Looking to program a Medfusion 3500 with drug protocols. If anyone has software or knowledge on how to get that done please let me know. Thanks
supertek0101@gmail.com
Oh that is good to know. I have another unit now with the PharmGuard program but do not know how to put the library/ protocols onto it. I need an IR communicator and the PASS software correct?
If you put the units back to back, with the pole clamp bracket off, go into biomed programming and take the one you want to learn and the other into teach. You may be able to be successful this way. Otherwise you will have to get a cloning block from Smiths Medical part number 22-4099-01.
C2 Management closeout auctions take place on DOTmed.com. Bid today on 345 lots of medical equipment. Onsite or virtual inspection available. Appointments may be made through email at auctions@tryc2.com, or through phone at 540-955-5740.
SupertekDave
Medfusion 3500 Software / Programing
November 29, 2018 09:40
Hey there friends, Looking to program a Medfusion 3500 with drug protocols. If anyone has software or knowledge on how to get that done please let me know. Thanks
supertek0101@gmail.com
to rate and post a comment
Tommy Creal
re: Medfusion 3500 Software / Programing
November 30, 2018 09:37
Please reach out to us at Adepto Medical 913-261-9933.
We specialize in IV pumps and IV pump Service
Thank you
to rate and post a comment
Niki Pyrc
re: re: Medfusion 3500 Software / Programing
December 01, 2018 01:17
Do you have a pump that has the drug protocols already on it? If you do you can clone the one you need to have the same.
to rate and post a comment
SupertekDave
re: re: re: Medfusion 3500 Software / Programing
December 02, 2018 10:15
Oh that is good to know. I have another unit now with the PharmGuard program but do not know how to put the library/ protocols onto it. I need an IR communicator and the PASS software correct?
to rate and post a comment
Niki Pyrc
re: re: re: re: Medfusion 3500 Software / Programing
December 03, 2018 10:04
If you put the units back to back, with the pole clamp bracket off, go into biomed programming and take the one you want to learn and the other into teach. You may be able to be successful this way. Otherwise you will have to get a cloning block from Smiths Medical part number 22-4099-01.
to rate and post a comment