We provide sales, service, rental, and repair for ultrasound systems, probes, and C-arms. We have the largest inventory in the world. Contact us about our special offers on certified refurbished equipment! Call: 317-759-9210 Email: sales@probomedical.com.
Dante Nuevo
Logiq 700 software problem.
September 23, 2016 09:40
Good day, my dear dotmed friends.
I am here to ask for your help to confirm an error.
I have a set of disk to reload a logiq 700 ultrasound, but the first disk is not working and has a very strange list of files.
aaaaaaa0aa.iq
aaaaaaa0ab.iq
and goes like that 19 times to complete 26MB.
I am not sure if this MO disk is good since I didn't check it before and because it appears to start reading the disk and then stops.
The other 3 disks appers to be on the same condition. I tested the disks with 3 different drives with the same result.
Please tell me if you have seen it before and if it is good.
Thanks for your kind help.
Dante Nuevo.
dantenuevo@hotmail.com
to rate and post a comment
Michele Di Lello
re: Logiq 700 software problem.
September 24, 2016 04:11
I do not know the file type, verify the operation of the floppy drive, this usually does not work because not used, it happened to me several times. regards
to rate and post a comment
Jim Carr
re: Logiq 700 software problem.
September 24, 2016 04:11
Hello Dante,
What version of software are you trying to load? Before rev 6 the probes should not be connected when trying to install software.
to rate and post a comment