When using remote, image, run or snapshot functions work fine. When trying to use STEP to cycle thru one image at a time, system cycles thru several images without stopping. We tried a new remote and got the same symtoms. We replaced the VCCOM 2 board and got the same symtoms. We have eliminated the IR Receiver. Any suggestions as to the root of the problem would be greatly appreciated.
Jamie Reid
Integris H3000 VISUB Problem
January 24, 2007 10:26
When using remote, image, run or snapshot functions work fine. When trying to use STEP to cycle thru one image at a time, system cycles thru several images without stopping. We tried a new remote and got the same symtoms. We replaced the VCCOM 2 board and got the same symtoms. We have eliminated the IR Receiver. Any suggestions as to the root of the problem would be greatly appreciated.
Thank you.
to rate and post a comment
Jorge Cid Alvarez
Re: Integris H3000 VISUB Problem
April 01, 2007 02:13
Dear Sirs,
I have about 4 years experience on VISUB.
it looks as software problem
may the best were reinstall the options
JORGE CID ALVAREZ
electronic engineer.
jojo99@latinmail.com
56- 9-050 47 70
to rate and post a comment