okay a year and a half another company sold and installed a rp1 with this problem and i stumbled across it after taking over the service contract. In "S" tilt only top towards rear of gantry bottom towards table the unit will scan a patient in every speed but 2 second with a annode overcurrent error in all other respects the unit runs great. Also any degree from 2 to whatever if its "S" it errors. 1 sec helical all works in "S" tilt Hav'nt spent any toubleshooting time just checked the error because it was the end of a long trip and the customer did a by the way an hour before the plan left on of course friday thank guys
Altima will inspire the trust, loyalty and commitment of our customers through positive relationships and collaboration, top quality equipment services, and a clearly superior value proposition. Call Today (469) 644-7063
Dean Kenney
HSA rp1 2 second scan problem
January 18, 2006 04:06
okay a year and a half another company sold and installed a rp1 with this problem and i stumbled across it after taking over the service contract. In "S" tilt only top towards rear of gantry bottom towards table the unit will scan a patient in every speed but 2 second with a annode overcurrent error in all other respects the unit runs great. Also any degree from 2 to whatever if its "S" it errors. 1 sec helical all works in "S" tilt Hav'nt spent any toubleshooting time just checked the error because it was the end of a long trip and the customer did a by the way an hour before the plan left on of course friday thank guys
to rate and post a comment
Mike Lynch
Re: HSA rp1 2 second scan problem
January 18, 2006 10:36
You probably have an intermittent power supply problem or STC board problem. Try reseating the board and check its power supply.
to rate and post a comment