Found a problem with a CT Hispeed DXi
Heater Error: Filament Selection Error
XG Error
phase is 3 code is 50
detail error code: 50-0215H
I would like if this problem could be a different cause than HEATER V3 Assy (Filament Board 1 Inv) as Diagnostics Manual indicate, this is located in to Auxiliary Module
Thanks
From preventive maintenance through comprehensive cryogen services, BMI-PMI is your trusted partner for new/reconditioned sales, installation, and service of both facility-based and mobile MRI solutions. www.brownsmedicalimaging.com / 800-701-9729
Manuel Esquer
Hispeed Filament Selection Error
April 23, 2012 11:45
Found a problem with a CT Hispeed DXi
Heater Error: Filament Selection Error
XG Error
phase is 3 code is 50
detail error code: 50-0215H
I would like if this problem could be a different cause than HEATER V3 Assy (Filament Board 1 Inv) as Diagnostics Manual indicate, this is located in to Auxiliary Module
Thanks
to rate and post a comment
Lin Dong
re: Hispeed Filament Selection Error
April 24, 2012 06:22
Hi
the heater board is bad.
to rate and post a comment
nilo panlilio,jr
re: Hispeed Filament Selection Error
May 01, 2012 08:38
try to replace heater v3.
to rate and post a comment