The unit right now cannot move the hydraulics(Lateral tilt and Trendelenburg cylinders). The unit Remote Control/Handset faulty but already being repaired and tested with other unit. It works normally.
There are no error shown on the OT Table at the Remote Control/Handset. But unit still cannot move the Hydraulics(Lateral tilt and Trendelenburg cylinders). The Relay on the mainboard are in good condition due to being tested with Remote Control/Handset, It gives an audible relay sound when pressed the button on the Remote Control/Handset.
One of the hydraulics cylinder (Lateral tilt cylinder) had the greenish stain on it. I suspected the Hydraulics cylinder faulty. Is there any possible of other faulty that causing the other part stuck too?
Any suggestion on this matter for this Operating Theatre Table, Eschmann RX500 series?
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Muhammad Luqman
Eschmann RX500
February 09, 2021 09:55
The unit right now cannot move the hydraulics(Lateral tilt and Trendelenburg cylinders). The unit Remote Control/Handset faulty but already being repaired and tested with other unit. It works normally.
There are no error shown on the OT Table at the Remote Control/Handset. But unit still cannot move the Hydraulics(Lateral tilt and Trendelenburg cylinders). The Relay on the mainboard are in good condition due to being tested with Remote Control/Handset, It gives an audible relay sound when pressed the button on the Remote Control/Handset.
One of the hydraulics cylinder (Lateral tilt cylinder) had the greenish stain on it. I suspected the Hydraulics cylinder faulty. Is there any possible of other faulty that causing the other part stuck too?
Any suggestion on this matter for this Operating Theatre Table, Eschmann RX500 series?
to rate and post a comment