if you only have the service manual, it is not enough, you must
get the service software to connect the machine and diagnostic
and test it, i have all service manuals and service
software,install software of AGFA DRY3000, if you need any help,
please contact obnauy@163.com
Error Code --> 6c841
E_T14_S8_MALFUNCTION,
Meaning : During a drum-calibration only a single
encoder-readout has been obtained. This is
not correct. A malfunction caused this
error-condition.
Reason : Possible malfunction or disconnection of
the drum-(slit-)sensor . As a result, since
no sensor-transitions are spotted, only a single
encoder read-out has been spotted.
Cure : a. Check sensor s8.
b. Replace the sensor.
c. Check the wirings.
d. Check the PMC-board functioning and release stamps.
Sometimes, we have the same error, but after off/on, it's ok.
I had the same error and we have fixed ours. solution: Just replace the larger belt located on the left side of the printer. That's all we did and it resolved our problem. Goodluck.
One call to 440-263-6575 and your move will be covered.
We repair & store trailers. We build to your custom needs.
JDI Mobile Medical Manufacturing. Inc. We have your back.
Dale Lumbra
AGFA DS 3000 ERROR 6C841
October 20, 2010 01:11
I AM HAVING AN ISSUE ON BOOT UP SYSTEM COMING UP WITH ERROR 6C841 SOUNDS LIKE BAD SENSOR BUT WHICH ONE ANY HELP APPRECIATED.
to rate and post a comment
yuan bo
Re: AGFA DS 3000 ERROR 6C841
October 21, 2010 09:34
if you only have the service manual, it is not enough, you must
get the service software to connect the machine and diagnostic
and test it, i have all service manuals and service
software,install software of AGFA DRY3000, if you need any help,
please contact obnauy@163.com
to rate and post a comment
- -
Re: AGFA DS 3000 ERROR 6C841
October 22, 2010 07:51
6C841
Error Code --> 6c841
E_T14_S8_MALFUNCTION,
Meaning : During a drum-calibration only a single
encoder-readout has been obtained. This is
not correct. A malfunction caused this
error-condition.
Reason : Possible malfunction or disconnection of
the drum-(slit-)sensor . As a result, since
no sensor-transitions are spotted, only a single
encoder read-out has been spotted.
Cure : a. Check sensor s8.
b. Replace the sensor.
c. Check the wirings.
d. Check the PMC-board functioning and release stamps.
Sometimes, we have the same error, but after off/on, it's ok.
to rate and post a comment
Thomas Onyema
Re: AGFA DS 3000 ERROR 6C841
October 29, 2010 11:44
Have you been able to fix this error?
to rate and post a comment
Thomas Onyema
Re: AGFA DS 3000 ERROR 6C841
November 08, 2010 11:23
I had the same error and we have fixed ours. solution: Just replace the larger belt located on the left side of the printer. That's all we did and it resolved our problem. Goodluck.
to rate and post a comment