Thank you so much for your help so far. This the provided manuals and software, I was able to repair this Insight2 with a used intensifier power supply. It works great, however it cuts off the top of the screen. I don't see that I can post a picture so I'll give you a dropbox link: https://www.dropbox.com/s/7qr5ip4op7hth22/flouroscan.jpg?dl=0
I have run the antiwarp with the mesh. Not sure how to adjust this.
Michael Berry
Flouroscan Insight 2 cutting off top
January 23, 2020 11:05
Thank you so much for your help so far. This the provided manuals and software, I was able to repair this Insight2 with a used intensifier power supply. It works great, however it cuts off the top of the screen. I don't see that I can post a picture so I'll give you a dropbox link: https://www.dropbox.com/s/7qr5ip4op7hth22/flouroscan.jpg?dl=0
I have run the antiwarp with the mesh. Not sure how to adjust this.
Thanks!
-Mike
to rate and post a comment
Michael Berry
re: Flouroscan Insight 2 cutting off top
January 31, 2020 10:21
Bummer. No one has an idea? Guess I'll try running the antiwarp again.
to rate and post a comment