I replaced a hard drive on a logiq 3 expert I found the software at the office (BEP and application 4.0.2.) and reloaded it.
Darn thing works most of the time but when I put all the panels on and turn the main switch on the scanner fires but when pressing the on-off button the PC does not start up.
When I disconnect all power open the PC remove the BIOS jumper for a second and put it back on pin 1-2 (normal operation) and press the power button the pc starts up just fine.
When testing it might start 4-5 times and then stops again.
Anybody seen that before? also what are the recommended BIOS settings with BEP4 installed (this machine has not been used in a long time)
(1)
Lucas Ronde
logiq 3 back-end processor not always booting
March 05, 2015 05:19
I replaced a hard drive on a logiq 3 expert I found the software at the office (BEP and application 4.0.2.) and reloaded it.
Darn thing works most of the time but when I put all the panels on and turn the main switch on the scanner fires but when pressing the on-off button the PC does not start up.
When I disconnect all power open the PC remove the BIOS jumper for a second and put it back on pin 1-2 (normal operation) and press the power button the pc starts up just fine.
When testing it might start 4-5 times and then stops again.
Anybody seen that before? also what are the recommended BIOS settings with BEP4 installed (this machine has not been used in a long time)
to rate and post a comment
(7)
akarsanov
re: logiq 3 back-end processor not always booting
March 09, 2015 08:28
What is your e-mail?
to rate and post a comment
(1)
Lucas Ronde
re: re: logiq 3 back-end processor not always booting
March 09, 2015 04:22
dutchy@ftatf.com
to rate and post a comment
(109)
(2)
Marcelo Antonio Correa
re: logiq 3 back-end processor not always booting
March 09, 2015 04:22
Dear Lucas, hi!
I suspect BEP's motherboard has some blown capacitors, the behaviour you're mentioning seems to point to this kind of failure.
Also, reattach the processor and memory combs, check overall motherboard's integrity.
Hope these help, take care, God Bless.
Kind regards,
MAC.
to rate and post a comment